Knowledge Base Help Center


< All Topics

How to fix an Apple joystick when the buttons stop working

By John Veldezco
Original article

If you find the joystick buttons on your Apple joystick aren’t working consistently anymore, then it might be time to replace the switches.
Link to buy it from Mouser
The part you will want to get is the Omron B3F-4000, which is good for another 3,000,000 button presses.

You can also choose to get the long service life version, the Omron B3F-5000, which is good for another 10,000,000 operations. 🙂

You will also need a long enough phillips-head screwdriver, and your trusty soldering iron and some solder.
Next step, opening up the joystick. The screws are hidden behind the rubber foot pads on the bottom of the joystick. You can pry the feet off gently and they should have enough adhesive to put back on again. Note that only two of them need removing (upper left and lower right as shown in the picture below).

You will see that the switches (grey color) have components soldered directly to them.

So with your soldering iron, carefully detach each wire and resistor connected to the switches. Remember where everything is supposed to go! I just take photos so I can refer back to them when it’s time for reassembly.

Here are the old switches after removal:

Finally, resolder the connections on to the new switches.

Done! Now get back to playing Alien Downpour…

Give your Apple joystick buttons new life by installing Omron B3F-5000 switches.

Table of Contents